Full coverage nail tips - Sheers Nude

Nail application with Cuccio Pro instant glue (included)

1. Prepare the nails by pushing back the cuticles, dehydrate the nail plate with Prep N' Scrub and pick out the tips. File the tips if necessary.
2. To adhere the tip, apply a small amount of Cuccio Pro Instant Glue to the inside of the tip and press onto the nail. Hold in place for a few seconds to let it set.

Nail application with Cuccio Pro Brush-On Builder

1. Prepare nails and push back cuticles. Dehydrate the nail with Prep N' Scrub.
2. Apply Cuccio Veneer Fuse or Primer to the entire natural nail.
3. Measure the nail tips on all ten fingers so they are ready.
4. Polish the interior contact area of ​​the tips to remove shine.
5. Apply a thin layer of Brush-On Builder to the natural nail and cure for 10 seconds under the LED lamp.
6. Apply the Cuccio Pro Brush-On Builder to the inner filed area of ​​the full coverage tip, flip it over and apply it to the nails at a 45 degree angle to eliminate air bubbles, and press into place until until the gel fills the natural nail. If possible, clean off any excess gel from the sides of the nail.
7. Hold the tip in place, run under the light and continue to hold for 10 seconds, then release and continue to cure for a full minute. It is important to hold the tip at first while the light sets it in place before releasing it and completing full curing. Once the whole hand is complete, cure under a LED/UV lamp for 30 seconds.